From rooftop Shams Dubai systems to utility PV and battery plants, we engineer the part that makes solar behave on the grid: protection, SCADA, power plant controllers and hybrid power management, tested to the utility's rules.
Closed-loop control at the point of interconnection: active and reactive power setpoints, voltage and power-factor modes, frequency response, ramp-rate limits and curtailment from the grid operator.
P/Q, voltage and power-factor control at the POI
Frequency response (P-f droop) and ramp-rate limits
Curtailment and export limitation
Setpoints from utility SCADA over IEC 61850, IEC 60870-5-104, DNP3 or Modbus
Grid-code compliance tests and reports
Shams Dubai & DRRG
Rooftop and ground-mounted systems for DEWA's Shams Dubai net-metering initiative, designed to DEWA's DRRG standards and connection guidelines.
Design to DRRG standards and connection guidelines
Equipment registered on DEWA's DRRG equipment portal
Protection settings, metering and export control
Inspection, testing and DEWA connection support
Monitoring and O&M after connection
D33 captive solar for industry
Dubai's D33 agenda brought an industry-friendly power policy: factories, data centres and agri-tech sites can install captive solar up to their connected load. We size, integrate and control these plants alongside the existing supply.
Load studies and captive-plant sizing
Integration with MV/LV switchgear and gensets
Export limitation and zero-export control
Energy and fuel-saving dashboards
Expansion to BESS and hybrid operation
Hybrid PV + BESS + genset
Power management for off-grid and weak-grid sites: generators kept above minimum load, spinning reserve maintained, batteries charged from PV surplus and fuel saved every hour.
Minimum-load and spinning-reserve logic
BESS charge/discharge strategies
Island and grid-parallel operation
DEIF, Woodward, ComAp-class and Logix-based PMS
Fuel and CO₂ savings reporting
POWER PLANT CONTROL
One controller between the grid and the plant.
The PPC reads the point of interconnection, takes setpoints from the grid operator and dispatches every inverter, battery and generator so the plant meets the grid code.
Shams Dubai is an initiative of the Dubai Electricity and Water Authority (DEWA). Requirements referenced here follow DEWA's published DRRG standards and connection guidelines; project-specific enrolment and approvals are confirmed per project.
START A CONVERSATION
Tell us about your plant. We will tell you how we would deliver it.
Send an RFQ, a single-line diagram or just a description of the problem. An engineer replies, not a call centre.